Installing components

Testing the stop lamp

Fig 1: Identifying Stop Lamp Connected

Courtesy of VOLVO CARS OF NORTH AMERICA.

Connect a new stop lamp.

Check its function.

Disconnect it.

Removing the backing

Fig 2: Identifying Double Sided Adhesive Backing

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the backing (1) from the double-sided adhesive tape on the stop lamp.

Installing the stop lamp

Fig 3: Identifying Stop Lamp Positioned On Headlining With Bevel

Courtesy of VOLVO CARS OF NORTH AMERICA.

Position the stop lamp on the headlining with the bevel (1)against the headlining.Do not allow the double-sided adhesive tape touch the headlining.

NOTE:

To avoid squeaking it is important that the stop lamp is correctly positioned on the headlining.

Press the stop lamp into place on the headlining.

Finishing work

Fig 4: Identifying Stop Lamp Components

Courtesy of VOLVO CARS OF NORTH AMERICA.

Connect the connector (1) to the stop lamp.

Tape (2) stop lamp wiring to the headlining so that they cannot make a noise.

Install foam rubber (3), just behind the hole for the rear interior lighting. Use contact adhesive, P/N 1161434, if there is too little adhesive left on the foam rubber for it to stick to the headlining.

Install clip (4) in the headlining by pressing straight up and twisting a quarter turn.

Install the interior lighting (5) by pressing straight up.