Connecting the breakout box
Special tools:
Avoid touching control module connector pins and corresponding cable harness connectors. There is a risk of electrostatic discharge, which could damage the control module. Relieve any charge on yourself and the tools to be used by holding the metal part of the tool and touching part of the body just before starting work.
General information
Visually check the connectors to ensure that the male and female terminals are not damaged and that the cables are properly connected in the terminals.
The breakout box is designed to make it easier to take readings from cables and components when the control module is disconnected. The use of a breakout box reduces the risk of accidental short-circuited cables and damage to the connector pins.
Connecting the breakout box
- Ignition off.
- Disconnect the control module connector.
Connect adapter 9511510 to the control module connector. Connect one or two breakout boxes 9511428 to the adapter depending on the reading to be taken.
Disconnect the breakout box in reverse order.
Other information:
- To access / replace the SRS control module and connectors, see Supplemental restraint system module (SRS), replacing .
- For the location of the components, see Location of components .
- For other values, see Signal specification .