Checking the wiring and component

Fig 1: Identifying Ignition OFF

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off.

  Check the communication cable between gear selector control module terminal #2 and transmission control module (TCM) terminal #B31 (#B21). Check for an open-circuit. See Open-circuit, permanent faults .

  Replace the circuit board in the top panel if no fault is found in the cable.

  Remedy as necessary.

  Other information: 

  • To connect the breakout box, see Connecting the breakout box
  • To replace the circuit board in the top panel (standard, V70), see Printed circuit board gear selector assembly/top panel, replacing
  • To replace the circuit board in the top panel (geartronic, V70), see Printed circuit board gear selector assembly/top panel Geartronic, replacing
  • For information about signals, see Signal description. Transmission control module (TCM) .
  Fig 2: Identifying Breakout Box

  Courtesy of VOLVO CARS OF NORTH AMERICA.
  Fig 3: Identifying Ohms Display

  Courtesy of VOLVO CARS OF NORTH AMERICA.

Was a fault detected? 

• YES 

  Refer to Verification 

• NO 

  FAULT NOT FOUND:  Troubleshooting has been completed.