Checking the wiring: Notes
- Ignition off.
Check the signal cable between control module terminal #A47 (#A47) and camshaft position (CMP) sensor connector terminal #3. Check for a short-circuit to ground. Check the power cable between control module terminal #A29 (#A29) and camshaft position (CMP) sensor connector terminal #1. Check for an open-circuit.
HINT: With the ignition on and the camshaft position (CMP) sensor connector disconnected, the voltage between terminal #1 and ground terminal should be approximately 5 V.
Remedy as necessary.
Other information
- To connect the breakout box / access the control module, see Connecting the breakout box
- For the location of components on 5 cylinder engines:
- For 5 cylinder turbocharged engines -2001, see Location of components
- For 5 cylinder turbocharged engines 2002, see Location of components, engine compartment
- For 5 cylinder turbocharged engines 2003-, see Location of components, engine compartment
- For B5254T4 2004-, see Location of components, engine compartment .
- For information about signals:
- For 5 cylinder turbocharged engines -2001, see Signal specification
- For 5 cylinder turbocharged engines 2002, see Signal specification
- For B5254T2 -2004, see Signal description
- For B5204T5, B5234T3, B5234T7 and B5244T3 -2004, see Signal specification (B5204T5, B5234T3, B5234T7 and B5244T3 -2004)
- For B5254T4 2004, see Signal specification (B5254T4 2004)
- For 5 cylinder turbocharged engines 2005-, see Signal specification .
- See Checking wiring and terminals .
- Continue
Refer to Verification