Diagnostic trouble code (DTC) information

Condition 

If engine speed (RPM) is above 600 rpm, vehicle speed is 0 km/h and the engine control module (ECM) has not registered that the ignition key has been turned to start position (when the starter motor should begin to operate), it is interpreted as a fault - signal too low. If the control module receives a signal that the ignition key has been turned to start position while driving (under certain driving conditions), it is interpreted as a too high signal. The engine control module (ECM) will then store ECM-5200.

Substitute Value 

None.

Possible Source 

Signal too high: 

• signal cable short-circuited to supply.

Signal too low: 

• short-circuit to ground in the signal cable
• open-circuit in the signal cable.

Fault symptom[s] 

None.