Checking The Component And Wiring

HINT: If the diagnostic trouble code (DTC) for the gear-shift position sensor is stored in the transmission control module (TCM), this diagnostic trouble code (DTC) must be remedied first. 

• Check the connector for the transmission control module (TCM) control module. Check for contact resistance. Check for oxidation.

  Check the signal cable between engine control module (ECM) terminal #B15 (#C15) and transmission control module (TCM) terminal #5. Check for an open-circuit. Check for a short-circuit to supply voltage. Check for a short-circuit to ground.

  Remedy as necessary.

  Other information 

  • see CONNECTING THE BREAKOUT BOX
  • see SIGNAL SPECIFICATION (2005), or SIGNAL SPECIFICATION (2006-2007)
  • see CHECKING WIRING AND TERMINALS
  Fig 1: Identifying VCT2000 Diagnostic Tool Symbol In VIDA

  Courtesy of VOLVO CARS CORPORATION
  Fig 2: Identifying Shifter

  Courtesy of VOLVO CARS CORPORATION

• Continue 

  Refer to VERIFICATION