Checking Components And Wiring

Check the signal cable between engine control module (ECM) terminal #A60 (#A60) and camshaft position (CMP) sensor connector terminal #3. Check for a short-circuit to ground.

Check the power cable between engine control module (ECM) terminal #A16 (#A16) and camshaft position (CMP) sensor connector terminal #1. Check for an open-circuit.

HINT: With the ignition on and the camshaft position (CMP) sensor connector disconnected, the voltage between terminal #1 and ground terminal should be approximately 5 V. 

Remedy as necessary.

Other information 

• see CONNECTING THE BREAKOUT BOX
• see SIGNAL SPECIFICATION
• see CRANKSHAFT POSITION SENSOR (CKP)
• see CHECKING WIRING AND TERMINALS

Fig 1: Identifying 3-Bit Connector

Courtesy of VOLVO CARS CORPORATION

Fig 2: Identifying VCT2000 Diagnostic Tool Symbol In VIDA

Courtesy of VOLVO CARS CORPORATION

Fig 3: Detecting Camshaft Flanks On Sensor

Courtesy of VOLVO CARS CORPORATION

• Continue 

  Refer to VERIFICATION