Diagnostic trouble code (DTC) information
Condition
The gearbox output speed sensor gives the transmission control module (TCM) a signal on the speed of the output drive shaft. Using this signal, the control module can calculate the output speed of the gearbox. The signal is compared with a signal from the gearbox input speed sensor and is used to calculate the gear ratio of the gearbox as well as for diagnosis.
If the transmission control module (TCM) registers that the speed signal from the brake control module (BCM) does not agree with the signal from the output speed sensor, the diagnostic trouble code (DTC) is generated.
The diagnostic trouble code (DTC) can be diagnosed at speeds above approximately 30 km/h and engine speeds above 400 RPM.
Substitute Value
- Adaptation function is blocked.
- Lock-up function is blocked.
- Slip lock-up function is blocked.
- Neutral check function is blocked.
- The transmission control module (TCM) uses the speed signal that the brake control module (BCM) puts on the CAN network.
- If the speed signal from the brake control module (BCM) is also missing, the auxiliary program Emergency mode 1 in the transmission control module (TCM) will become active.
Possible Source
- Contact resistance in the terminals
- Transmission's output speed sensor is not fitted correctly.
- Gearbox output speed sensor not working.
- The wheel radius does not agree with the wheel radius programmed in the vehicle's configuration file.
Fault symptom[s]
- Malfunction indicator lamp (MIL) lit.
- General warning lamp lit
- No lock-up function.
- Harsh gear changing
- No gear changing.