Checking the wiring

Check the signal cable between control module terminal #A47 (#A47) and camshaft position (CMP) sensor connector terminal #3. Check for a short-circuit to ground. Check the power cable between control module terminal #A29 (#A29) and camshaft position (CMP) sensor connector terminal #1. Check for an open-circuit.

HINT: With the ignition on and the camshaft position (CMP) sensor connector disconnected, the voltage between terminal #1 and ground terminal should be approximately 5 V. 

Remedy as necessary.

Other information 

• To connect the breakout box / access the control module, see Connecting the breakout box
• For the location of components on 5 cylinder engines, see ENGINE & FUEL - SENSORS & COMPONENT LOCATIONS
• For information about signals, see ELECTRICAL SYSTEM
• See Contents .

Fig 2: Identifying Control Module Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Ohmmeter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 4: Identifying Camshaft Position (CMP) Sensor

Courtesy of VOLVO CARS OF NORTH AMERICA.

Refer to Verification