Checking Power Supply And Ground Terminals For The Throttle Unit: Notes
Checking power supply terminal
- Check fuse 11 B/21. If the fuse is blown check the circuit after the fuse for a short-circuit to ground according to Short-circuit to ground, permanent faults .
- Check power supply to throttle unit #6. Voltage should be approximately battery voltage.
Checking ground terminal
- Check ground lead between throttle unit #5 and engine ground terminal ETM 31/91 for an open-circuit according to Open-circuit, permanent faults .
- Check throttle unit ground terminal for contact resistance and oxidation according to Contact resistance and oxidation .
Remedy as necessary
Other information
- Power supply to the electronic throttle module #6 is from fuse 11 B/21 via the system relay.
- Ground terminal 31/91 for the electronic throttle module is located on the front of the cylinder block above the starter motor
- For information about other signals, see Signal specification .
- For further information about the circuit, see the relevant wiring diagram
Are the power supply and ground terminals OK?
- YES
OKAY: Troubleshooting has been completed.
- NO