Calibrating the sun roof module (SRM)
The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.
The sun roof must be closed.
Ignition in position I.
1
Press the sun roof switch so that the sun roof is in the tilt position.
Release the switch.
2
Press the switch (in the tilt position) in again for at least 5 seconds so that the sun roof closes.
Release the switch.
The calibration is complete.
If the sun roof has not moved to the correct position, carry out calibration again.
HINT: If the sun roof has still not moved to the correct position:
HINT: Press the sun roof switch so that the sun roof moves to the rearmost position (completely open).
HINT: Release the switch.
HINT: Press the switch (in the completely open position) in again for at least 5 seconds so that the sun roof closes.
HINT: Release the switch.
HINT: Close the sun roof and carry out calibration again.
For further information on the sunroof, see
See Design
See Function