Checking the wiring
Check the power supply cable between rear electronic module connector terminal #B20 (#D20) and tilt sensor connector terminal #1. Check for a short-circuit to ground.
If no fault was found, try a new sensor.
Other information
- For further information about signals and other values, see Signal specification
- To connect the breakout box, see Connecting the breakout box
- To access the rear electronic module, see Integrated relay/fuse box cargo compartment/rear electronic module, replacing
- To access and replace the tilt sensor, see Tilt sensor alarm, replacing
- See Checking wiring and terminals. Permanent fault .
- Continue
Refer to Verification