Checking components and wiring
Check that the "15I supply" relay 2/52 is intact. Check that the relay is correctly installed.
Check that fuse 11D/5 is intact.
Check the cable between fuse 11D/5 and "15I supply" relay 2/52 #1. Check the cable between the rear electrical module terminal #D2 (#B02) and "15I supply" relay 2/52 #2. Check for an open-circuit.
Check the relay terminals. Check for an open-circuit.
Remedy as necessary.
Try a new relay if no faults are found.
Other information:
- To connect the breakout box, see Connecting the breakout box
- For information about signals, see Signal specification
- When the relay is installed and activated, the voltage at the relay guide must be 12 V
- See Checking wiring and terminals .
- Continue
Refer to Verification