Generator (GEN), replacing (D5244Tx, - 2004): Installation

• Position the generator (GEN) so that the screw and nut that run through it can be installed in the upper mounting. Do not tighten
• Connect the cable and the connector
• Install the lower screws for the generator (upper screws for the compressor).

Without A/C: 

• Tighten the screws. Tighten to 25 Nm  .

With A/C: 

• Tighten the lower screws for the compressor. Tighten to 25 Nm 
• Tighten the screw and nut that run through the upper mounting. Tighten to 25 Nm  .

• Carry out the remaining operations in reverse order.
  CAUTION:

  When removing and installing the battery leads. See Battery, disconnecting .