Checking the component and cable

Fig 1: Identifying Ignition OFF

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off.

  Check the cable between central electronic module (CEM) connector terminal #20A and ignition switch connector terminal #50. Check for a short-circuit to supply voltage. Check for an open-circuit.

  Other information: 

  • The voltage must be 0 V if the key is in position 0, I or II
  • To access or replace the central electronic module (CEM) connector, see Central electronic module (CEM), replacing
  • For the intermediate connector see appropriate wiring diagram.
  • To connect the breakout box to the control module, see Connecting the breakout box
  • For further information about signals and other values, see Signal specification
  • See Checking wiring and terminals .
  Fig 2: Identifying Breakout Box

  Courtesy of VOLVO CARS OF NORTH AMERICA.
  Fig 3: Identifying Voltage Display

  Courtesy of VOLVO CARS OF NORTH AMERICA.
  Fig 4: Identifying Central Electronic Module (CEM) Connector Terminals

  Courtesy of VOLVO CARS OF NORTH AMERICA.

Were any faults found in the cable? 

• YES 

  Refer to Verification 

• NO 

  Refer to Replacing ignition switch connector