LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2007 >> S60 Base, AWD >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Climate Units - General Diagnostics And Tests >> Connecting The Breakout Box, Climate Control Module (CCM) (2001-2004) >> Connecting the Breakout Box >> Climate Control Module (CCM), Replacing >> Preparations

Climate Control Module (CCM), Replacing: Preparations

Fig 1: Identifying Ignition Key Off
GLL103058Courtesy of VOLVO CARS OF NORTH AMERICA.
NOTE: Read out the programmed data before replacing the climate control module. This is done in VIDA vehicle communication. After replacing the climate control module (CCM), the relevant parameters must be programmed.

Move the gear selector/gear selector lever to the rearmost position.

Ignition off.

Remove the key. The key must be removed to ensure that the ignition is not switched on by mistake.

WARNING: After the key has been removed, wait three minutes before starting work.

Removing the climate control module (CCM) 

Fig 2: Detaching Panel At Gear Selector Lever
GLL108231Courtesy of VOLVO CARS OF NORTH AMERICA.

Detach the panel at the gear selector lever as illustrated.

Twist the panel so that it is as far from the center console as possible.

Fig 3: Identifying Bracket Lower Screws & Infotainment Control Module (ICM)
GLL108218Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the lower screws from the bracket.

Angle out the entire infotainment control module (ICM) and the dashboard environment panel as illustrated.

Fig 4: Identifying Infotainment Module Connectors And Screws
GLL108227Courtesy of VOLVO CARS OF NORTH AMERICA.

Disconnect the connectors.

Turn the infotainment module with the dashboard environment panel.

Remove the four screws as illustrated.

Fig 5: Identifying Infotainment Control Module Removal
GLL108229Courtesy of VOLVO CARS OF NORTH AMERICA.

Press the four clips and remove the infotainment control module by pulling it straight out as illustrated.

Fig 6: Identifying Dashboard Environment Panel Removal
GLL108233Courtesy of VOLVO CARS OF NORTH AMERICA.

Slacken off the two screws at the lower edge of the dashboard environment panel.

Pull the dashboard environment panel straight out from the bracket.

Installing the climate control module (CCM) 

Fig 7: Identifying Dashboard Environment Panel Screws & Infotainment Panel
GLL108275Courtesy of VOLVO CARS OF NORTH AMERICA.

Install: 

Screw the infotainment panel into place using the four screws.

Connect the connectors.

Angle in the upper section of the infotainment control module first. Then screw the lower edge into place using the two lower screws.

scientia non olet · About LEMON Manuals