Checking wiring and connectors (3)

Check the power supply cable between upper electronic module (UEM) connector terminal #10 and movement sensor connector terminal #1. Check for an open-circuit. Check for a short-circuit to ground. Check for an intermittent open-circuit.

Other information: 

• To connect the breakout box: Connecting the breakout box
• For information about upper electronic module (UEM) signals:Signal specification
• See Replacing the movement sensor
• See Checking wiring and terminals

Fig 1: 10 CD Changer Connector Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Connector Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Was a fault detected? 

• YES 

  Refer to Verification 

• NO 

  Refer to Checking wiring and connectors (4)