Checking wiring and connectors

Check the power supply cable between upper electronic module (UEM) connector terminal #10 and mass movement sensor connector terminal #1. Check for a short-circuit to supply voltage. Check for an intermittent short-circuit to supply voltage.

Other information: 

• For further information about signals and other values, see Signal specification
• To connect the breakout box, see Connecting the breakout box
• To replace the movement/rear level sensor, see Replacing the movement sensor
• See Checking wiring and terminals .

Fig 1: 10 CD Changer Connector Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Voltage Display

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Connector Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Continue 

  Refer to Verification