Signal Too High / Signal Missing / Faulty Signal: Verification: Verification

HINT: After carrying out the repair, check that the fault has been remedied.

Fig 1: Engine Start Verification

Courtesy of VOLVO CARS OF NORTH AMERICA.

Reinstall the connectors, components etc.
Test drive the car at an even speed (engine speed (RPM) above 2000 RPM) for at least 4 minutes
Release the accelerator pedal (AP) quickly at least three times to simulate fuel shut-off
Connect VCT2000 to the data link connector (DLC) without switching off the engine.
NOTE:
If the engine is switched off, the stored fault status will be erased and the test drive will have to be repeated.

Read off the diagnostic status and the fault status for the diagnostic trouble code (DTC).

Check that the diagnostic is "Completed" and that the fault status is "No fault detected".

Fig 2: Identifying VCT2000 Diagnostic Tool Symbol In VIDA
Courtesy of VOLVO CARS OF NORTH AMERICA.

Is the fault status "No fault detected"?