Signal too low: Verification: Verification
HINT: After carrying out the repair, check that the fault has been remedied.
- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check the signal from the sun sensor by varying the light intensity at the sun sensor. Cover the sun sensor with your hand to obtain a minimal signal. Then direct a strong light source (for example a flashlight) at the sun sensor from close range to obtain a maximum signal.
The value must vary between approximately 0.5 and 4.85 V.
Is the function OK?
- YES
VERIFIED: Troubleshooting has been completed.
- NO
Refer to Information