Signal Too High: Verification: Verification

HINT: After carrying out the repair, check that the fault has been remedied. 

Fig 1: Identifying Ignition ON

Courtesy of VOLVO CARS CORPORATION

Fig 2: Connecting Connector

Courtesy of VOLVO CARS CORPORATION

• Ignition off
• Reconnect the connectors, reinstall components etc.
• Start the engine
• Ignition off
• Ignition on
• Read off the movement of the accelerator pedal by carefully depressing and releasing the accelerator pedal (AP).

  Check that the value changes with accelerator pedal movement. The value must be between approximately 0.4 V when the accelerator pedal (AP) is unaffected and approximately 4 V when the accelerator pedal (AP) is fully depressed.

  The fault has been remedied if the values are OK.

  Fig 3: Identifying VCT2000 Diagnostic Tool Symbol In VIDA

  Courtesy of VOLVO CARS CORPORATION

Are these values OK? 

• YES 

  VERIFIED:  Troubleshooting has been completed.

• NO 

  Refer to INFORMATION