Installing Removed Components

Install:

• the rubber mountings for the exhaust pipe
• SIPS (side impact protection system ) member
• the four screws for the SIPS (side impact protection system) member. Tighten to 24 Nm.

Install the four nuts and the screw holding the steering gear. Use new nuts and a new screw. Tighten to 50 Nm. Clip the cable in position.

Install:

• the ball joints. Use NEW nuts. Tighten to 80 Nm. Counterhold using a Torx wrench so that the ball joint boot is not damaged
• the anti-roll bar links. Use NEW nuts. Tighten to 50 Nm. Counterhold using a Torx wrench so that the boot is not damaged.

Install:

• the lower torque rod. Tighten the two screws. Tighten to 10 Nm
• the oil pipe for the steering gear from the snap fasteners along the sub-frame
• the screw clip for the steering gear return line
• any fuel line for engine block heater
• the screw for the cable duct
• the screw for the ground lead.