Checking The Control Unit

Remove window lift relay 2/117 from CEM socket.

Check the relay coil driver circuit for a short circuit to voltage supply by checking the voltage between #2 and ground in the relay socket to relay 2/117.

For additional information regarding short circuits to voltage supply, see SHORT-CIRCUIT TO SUPPLY VOLTAGE. PERMANENT FAULTS .

HINT: The voltage between #2 and ground should be approximately 0 volt. If the voltmeter indicates an incorrect value, the control unit must be replaced. 

Additional information 

• For -2004, see: CENTRAL ELECTRONIC MODULE (CEM), REPLACING
• For 2005-, see: CENTRAL ELECTRONIC MODULE (CEM), REPLACING .

Fig 1: Identifying Voltage Display

Courtesy of VOLVO CARS CORPORATION

Fig 2: Identifying Relays

Courtesy of VOLVO CARS CORPORATION

• Continue 

  Refer to VERIFICATION