LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2004 >> V70 R, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Disc) >> Bleeding Brake System >> Manual Bleeding

Manual Bleeding

WARNING: This page is about a different variant/trim than selected.
NOTE: Before bleeding brakes, ensure ignition is off. Clean around brake fluid reservoir filler cap before removing. Top-off brake fluid reservoir as necessary.
  1. Raise and support vehicle.
  2. Remove protective cap from left front bleed nipple.
  3. Connect the hose from collection bottle.
  4. Depress brake pedal a few times. Maintain pressure.
  5. Open left front bleed nipple.
  6. Depress brake pedal fully. Keep it fully depressed for approximately 5 seconds. Release it again.
  7. Repeat this 3-5 times until there are no air bubbles in fluid coming out of hose.
  8. Tighten bleed nipple.
  9. Remove hose from bleed nipple. Install protective cap.
  10. Repeat procedure for right front, left rear and right rear brakes. See BRAKE BLEEDING SEQUENCE  table.
BRAKE BLEEDING SEQUENCE

Application Sequence
V70, V70XC & XC70 LF, RF, LR & RR