Faulty signal. Permanent fault: Verification

HINT: After carrying out the repair, check that the fault has been remedied. 

• Raise the car so that the drive wheels are clear of the ground. Ensure that the car is secure.
• Start the engine and let it idle.
• Activate reading off the vehicle speed: Click on the VCT 2000 symbol.
• Shift gear selector to position D so that the drive wheels begin to rotate

  Depress the accelerator pedal (AP) and check that the speed is updated.

  NOTE:

  Ensure that the wheels are not rotating when the gear selector is moved.

  NOTE:

  Diagnostic trouble codes (DTCs) may be stored in the ABS system when the rear wheels are stationary and the front wheels rotate.

  Fig 1: Identifying VCT2000 Diagnostic Tool Symbol In VIDA

  Courtesy of VOLVO CARS OF NORTH AMERICA.

Was the signal updated? 

• YES 

  OKAY:  Troubleshooting has been completed.

• NO 

  Refer to Information