Checking cable and component

Check the cable between boost pressure sensor 2 (MAP) terminal #3 and control module terminal #13 for short circuit to supply voltage as described in Short-circuit to supply voltage. Permanent faults .

and the cable between boost pressure sensor 2 (MAP) terminal #2 and ground for open circuit as described in Open-circuit, permanent faults .

If no fault is detected during the above fault tracing, try a new boost pressure sensor 2 (MAP) as described in Boost pressure sensor 2, replacing as necessary.

Other information: 

• To connect the breakout box, see Connecting the breakout box. EMS 2000 .
• For information on signals, see Signal specification .

Fig 2: Identifying Boost Pressure Sensor Connector Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Boost Pressure Sensor

Courtesy of VOLVO CARS OF NORTH AMERICA.

Refer to Verification