Reading off input and output signals

Using this function, the values and status of the control module input and output signals can be continuously read off.

The following parameters can be read off: 

• the switch for high beam flash, input signal
• lighting switch, input signal
• high/low beam switch, input signal
• high beam, high beam warning lamp and the socket for auxiliary lamps, output signal
• low beam, output signal
• parking lamps, output signal
• tail lamps/side marker lamps, output signal
• rheostat turn angle
• lighting in the combined instrument panel, infocenter, cigarette lighter etc.
• switch for front fog lamps, input signal
• front fog lamps, output signal
• switch for the rear fog lamp, input signal
• rear fog lamp, output signal
• stop (brake) light switch, input signal
• back-up (reversing) lamp switch, input signal
• warning lamp for the bulb failure warning sensor, output signal
• intermittent wiper switch in the windshield wiper lever, input signal
• parking position switch in the windshield wiper motor, input signal
• windshield wiper motor via the windshield wiper lever, output signal
• switch for the windshield washer, input signal
• switch for the tailgate wiper, input signal
• tailgate wiper motor, output signal
• switch for the tailgate washer, input signal
• ignition switch position, input signal
• battery voltage. 15/2-supply from the ignition switch
• speed signal

For further information about parameters, see Description of parameters .