Signal missing. Permanent fault: Verification: Verification

HINT: After carrying out the repair, check that the fault has been remedied. 

Fig 1: Engine Start Verification

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Connector(s) Reinstallation

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off
• Reinstall the connectors, components etc.
• Raise the car so that the drive wheels are clear of the ground
• Start the engine and let it run at idle speed
• Shift gear selector to position D so that the drive wheels begin to rotate
• Read off the transmission speed.

  Check that the speed is updated

  NOTE:

  Diagnostic trouble codes (DTCs) may be stored in the ABS system when the rear wheels are stationary and the front wheels rotate. Erase any diagnostic trouble codes (DTCs) stored in the ABS system after fault-tracing.

  NOTE:

  Ensure that the wheels are not rotating when the gear selector is moved.

  Fig 3: Identifying VCT2000 Diagnostic Tool Symbol In VIDA

  Courtesy of VOLVO CARS OF NORTH AMERICA.

Was the speed updated? 

• YES 

  VERIFIED:  Troubleshooting has been completed.

• NO 

  Refer to Information