Checking the contact reel

Check that the upper connector on the switch for the cruise control is correctly connected.

Disconnect the upper switch on the switch for the cruise control. Take voltage readings between terminals #B1 (26) and #B3 (28) (on the cable connector). If the voltage is approximately 12 V the fault is probably in the switch for the cruise control.

Remedy as necessary.

Other information: 

• To access or replace the cruise control switch, see Keypad unit, steering wheel, replacing
• To replace the contact reel, see Contact reel/steering wheel angle sensor, replacing
• To access or replace the control module, see Steering wheel module (SWM), replacing
• To connect the breakout box, see Connecting the breakout box .

Fig 1: Breakout Box

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Voltage Display

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Continue 

  Refer to Verification