Data Link Connector

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying CAN Data Link Connector & Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

The data link connector is located in the passenger compartment near the driver's station. Cables for high-speed side (HS CAN) and low-speed side (LS CAN) are connected to the data link connector.

Fig 2: Identifying Standardized Pins On OBD II-Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

Pin 3 LS CAN (low-speed side) (H-cable)
Pin 4 Chassis ground
Pin 5 Signal ground
Pin 6 HS CAN (high-speed side) (H-cable)
Pin 11 LS CAN (low-speed side) (L-cable)
Pin 14 HS CAN (high-speed side) (L-cable)
Pin 16 Voltage feed

NOTE:

The data link connector's other connections may be used by other functions. This section only describes connections related to CAN.