Checking The Cable
WARNING: This page is about a different variant/trim than selected.
- Ignition off
- Disconnect the connector for the treble loudspeaker/upper loudspeaker in the right-hand door.
- Disconnect the 16-pin connector for the audio module (AUD).
HINT: The front right treble loudspeaker/upper loudspeaker and bass speaker are connected to these signal cables.
Check the cable terminals in the female and male sections of the connector. The cable terminals must not be damaged or pressed back.
Check the signal cable between the Audio module (AUD) terminal #B3 and treble/upper loudspeaker terminal #2 in the right-hand door. Check for a short-circuit to ground.
Check the signal cable between the Audio module (AUD) terminal #B11 and treble/upper loudspeaker terminal #1 in the right-hand door. Check for a short-circuit to ground.
Remedy as necessary.
Other information
- Continue
Refer to VERIFICATION