Checking The Component And Wiring

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Ignition OFF

GLL101045

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Disconnecting Connector

GLL101071

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ignition off
Disconnect the connector for the loudspeaker in the left front door.
Check the cable terminals. Check for contact resistance, loose connections and oxidation.

NOTE:
Only visually check the treble loudspeaker. Check for oxidation and loose connections. Do not carry out any electrical fault-tracing on the treble loudspeaker.

Check the cable terminals in the female and male sections of the connector. The cable terminals must not be damaged or pressed back.

Check the signal cable between audio control module (AUD) terminal #B1 and loudspeaker terminal #2 in the left front door. Check for an open-circuit.

Check the signal cable between audio control module (AUD) terminal #B9 and loudspeaker terminal #1 in the left front door. Check for an open-circuit.

HINT: Also check the connector between the audio control module (AUD) and the loudspeaker in the left front door for contact resistance, loose connections and oxidation.

Check loudspeaker connector terminals #1 and #2 in the left front door. Check for an open-circuit.

Remedy as necessary.

Other information
- see CONNECTING THE BREAKOUT BOX (2004, 2005, 2006)
- see SIGNAL SPECIFICATION (2004, 2005, 2006)
- see AUDIO MODULE
- see LOUDSPEAKER, SIDE DOOR FRONT
- see CHECKING WIRING AND TERMINALS
Fig 3: Identifying 2-Bit Connector
Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 4: Identifying 2-Bit Connector
Courtesy of VOLVO CARS OF NORTH AMERICA.

Continue
Refer to VERIFICATION