Servicing - A/T (Aw50/51 AWD)
- Application
- Oil Level, Checking
- Oil Grade, Checking
- Checking The Oil Level In The Bevel Gear
- Transmission Fluid, Replacing
- Resetting Transmission Fluid Change Counter
- Adjustments
- Removal, Replacement & Installation
- Bevel Gear, Replacing
- Notes
- Removal
- Installation
- Notes
- Installing The Bevel Gear
- Installing The Propeller Shaft
- Tightening The Propeller Shaft CV Joint
- Installing Members
- Installing The Drive Shaft And Bearing Cap On The Pilot Bearing For The Shaft
- Installing The Drive Shaft
- Checking The Oil Level In The Bevel Gear
- Installing Front Suspension Components
- Installing Front End Components, Continued
- Splines Greasing
- Installing The Sealing Ring For The CV Joint Housing On The Wheel Spindle
- Installing Wheels
- Sealing Rings Bevel Gear, Replacing
- Pinion Seal Bevel Gear, Replacing
- Three-Way Catalytic Converter (TWC), Replacing
- Boot, Gear Selector, Replacing
- Solenoid Shift Lock, Replace
- Removing Center Tunnel Console
- Cable Key Interlock, Replacing
- Gear Selector Cables, Replacing
- Gear Selector Knob, GEARTRONIC, Replacing
- Gear Selector Lever Assembly GEARTRONIC, Replacing
- Solenoid Control System, Replacing
- Cable Harness / Oil Temperature Sensor, Replacing
- Removal
- Preparations
- Removing The Air Cleaner (ACL) Housing
- Removing The Gear Selector Cable From The Lever On The Transmission
- Removing The Lever On The Gear Shift Linkage Rod
- Installing The Lifting Beams And Lifting Hooks On The Engine Lifting Lugs
- Removing The Sub-Frame
- Draining Transmission Fluid
- Removing The Control System Cover
- Removing The Cable Harness
- Installation
- Removal
- Sub-Frame Front, Replacing
- Notes
- Preparation
- Removing The Clamp For The Servo Pressure Hose
- Removing The Right Engine Mounting
- Removing The Splash Guard Under Engine
- Removing The Skid Plate
- Exposing The Sub-Frame
- Removing The Drive Shaft
- Removing The Sub-Frame
- Transferring Components
- Installing The Sub-Frame
- Installing Removed Components
- Installing The Drive Shaft
- Installing The Skid Plate
- Installing The Right-Hand Engine Mounting
- Installing The Clamp For The Servo Pressure Hose
- Removing Lifting Tools
- Finishing
- Sealing Ring, Gear Shift Linkage Rod, Replacing
- Gear-Shift Position Sensor, Position
- Cover Brake Cylinder B4 Automatic Transmission, Replacing
- Bevel Gear, Replacing
- Tightening Torque