Reading Off Input And Output Signals

This function can be used to continuously read off the values and status for the accessory electronic module (AEM) input and output signals.

The following parameters can be read off:

• Voltage supply to the accessory electronic module (AEM)
• Rheostat signal, the strength is given as a percentage
• Speed signal, given as a frequency where 512 is the highest frequency
• Voltage level of the signal to the relay, engine block heater
• Voltage level of the signal to the remote start module
• Voltage supply to the remote start unit
• Voltage level of alarm signals P0, P1, S0 and S1
• Voltage level of the signal to telemute
• Voltage level of the signal from telemute
• Power supply to the aerial amplifier.