Transmission - Checking/Fault Tracing, Installing (XC)
- Transmission
- Transmission checking/fault-tracing
- Transmission, installing
- Notes
- Transmission, installing (M66AWD 2004- and M66 2005-)
- Notes
- Installing the transmission
- Installing and tightening the screws for the transmission
- Installing the torque converter screws
- Lifting the engine and transmission
- Installing the rear engine mounting
- Installing the bevel gear
- Installing the lower oil pipe on the transmission
- Installing the left drive shaft on the transmission and the wheel spindle
- Installing the sub-frame on the bodywork
- Installing the right-hand drive shaft on the transmission, wheel spindle and control arm
- Installing components on the engine and sub-frame
- Checking the position of the tie rod in the steering gear
- Assembling the lower steering shaft
- Installing the cross members on the body
- Installing front suspension components
- Installing components for the fender liner
- Installing the cable duct
- Installing the front splash guard
- Removing the lifting beams
- Installing the coolant hose
- Installing the remaining screws for the transmission and starter motor
- Installing the gear selector cable and oil pipe
- Installing the service clips
- Installing engine compartment components
- Installing the battery lead
- Finishing
- Transmission, installing (B5244T3, AW50/51 AWD)
- Notes
- Installing the gearbox
- Adjusting the position of the engine and gearbox
- Installing and tightening the screws for the gearbox
- Installing the torque converter screws
- Lifting the engine and gearbox to the horizontal position
- Installing the rear engine mounting
- Installing the lower oil pipe on the gearbox
- Installing the bevel gear
- Installing the left drive shaft on the gearbox and the stub axle
- Installing the subframe on the bodywork
- Installing the right drive shaft on the gearbox, stub axle and control arm
- Tightening the subframe screws (both sides)
- Fitting the screws for engine pads and the torque rod bracket in the gearbox
- Installing the steering wheel shaft joint
- Installing the cross member
- Installing and tightening the front suspension components
- Installing the wiring duct
- Removing the lifting beam
- Installing the remaining screws for the gearbox and starter motor
- Installing the exhaust gas recirculation (EGR) cooler
- Installing the vacuum pump
- Installing the gear selector cable and oil pipe
- Installing service clips
- Installing engine compartment components
- Finishing
- Transmission, installing (AW55-50)
- Notes
- Installation
- Notes
- Installing the transmission
- Installing and tightening the screws for the transmission
- Installing the torque converter screws
- Lifting the engine and transmission
- Installing the rear engine mounting
- Installing the lower oil pipe on the transmission
- Installing the left drive shaft on the transmission and the wheel spindle
- Installing the subframe on the bodywork
- Installing the right-hand drive shaft on the transmission, wheel spindle and control arm
- Installing components on the engine and subframe
- Installing the servo pipe in the holders
- Installing the front mounting for the exhaust pipe
- Installing the cross members on the body
- Installing front suspension components
- Installing components for the fender liner
- Installing the cable duct
- Installing the front splash guard
- Removing the lifting beams
- Installing the coolant hose
- Installing the remaining screws for the transmission and starter motor
- Installing the gear selector cable and oil pipe
- Installing service clips
- Installing engine compartment components
- Checking the boot for the steering shaft/firewall
- Installing the battery lead
- Finishing
- Transmission replacement, post-checking