Diagnostic trouble code (DTC) information
Condition
The diagnostic trouble code (DTC) applies only to cars with dynamic stability and traction control (DSTC).
The brake control module receives a signal from the central electronic module (manual transmissions) or from the transmission control module (TCM) (automatic transmission) with information about the selected gear. If back-up (reverse) gear is selected, the stability function cannot be activated.
Diagnostic trouble code (DTC) BCM-0113 is stored if the brake control module registers that the signal is distorted, missing or receives a signal indicating that back-up (reverse) gear is selected when the car is being driven forward for more than one second.
The diagnostic trouble code (DTC) can be diagnosed when speed exceeds 40 km/h and the vehicle is driven straight ahead followed by a turn.
Substitute Value
- None.
Possible Source
- Open-circuit or short-circuit in the circuit for the back-up (reversing) lamp switch (manual transmission)
- Interference in the Control area network (CAN)
- Short-circuit or open-circuit on the Control area network (CAN).
This diagnostic trouble code (DTC) is not due to an internal hardware fault in the Brake control module (BCM) and must not be remedied by replacing the control module.
Fault symptom[s]
- None.