Signal missing. Permanent fault: Verification: Verification
HINT: After carrying out the repair, check that the fault has been remedied.
NOTE:
This test cannot be performed if there are diagnostic trouble codes (DTCs) stored in EMS2000.
- Reinstall the components, reconnect the connectors etc.
- Ignition on
- Check that no other diagnostic trouble codes (DTCs) are stored. If other diagnostic trouble codes (DTCs) are stored, these must be remedied and erased first.
Are any other diagnostic trouble codes (DTCs) stored?
- YES
Refer to Fault-tracing information:
- NO
Refer to Activating the leak diagnostic