Checking wiring and terminals
- Disconnect the connectors for the control module for the steering wheel angle sensor and the steering wheel module (SWM)
- Connect the breakout box.
Check the cable between the control module for the steering wheel angle sensor terminal #7 (#A31) and steering wheel module (SWM) terminal #14 (#A14). Check for an intermittent open-circuit according to Open-circuit, intermittent faults .
Check the wiring between the control module for the steering wheel angle sensor:
terminal #9 (terminal (#A33) and steering wheel module (SWM) terminal #12 (terminal #A12)
terminal #8 (terminal (#A32) and steering wheel module (SWM) terminal #7 (terminal #A7)
check for an intermittent short-circuit to supply voltage according to Short-circuit to supply voltage, intermittent faults .
Other information:
- To connect the breakout box to the control module for the steering wheel angle sensor, see Connecting the breakout box to the steering angle sensor
- To connect the breakout box to the steering wheel module (SWM), see Connecting the breakout box .
- To replace the steering wheel angle sensor, see Contact reel/steering wheel angle sensor, replacing
- For information about signals for the control module for the steering wheel angle sensor, see Signal description, Control unit for the steering wheel angle sensor (SAS)
- For information about signals for the steering wheel module (SWM), see Signal specification .
- Continue
Refer to Information