Transmission - Service Procedures (XC)
- Transmission
- Installing left drive shaft on transmission, wheel spindle and control arm
- Installing lifting beam and lifting hook on engine lifting eyelet
- Removing drive shaft from viscous coupling
- Transmission fluid, replacing
- Transmission oil / filter, preparations before replacing
- Transmission, installing
- Notes
- Checking before installing
- Adjust position of engine / transmission
- Install and tighten screws for transmission
- Install torque converter screws
- Install sub-frame components
- Lift up engine and transmission to horizontal position
- Install rear engine mounting
- Install sub-frame on bodywork
- Install left drive shaft on transmission, wheel spindle and control arm
- Install right drive shaft in transmission, wheel spindle and control arm
- Install and tighten sub-frame screws
- Install oil pipe on transmission
- Install and tighten suspension components (both sides)
- Tighten ball joint pinion
- Install new lock nuts on steering gear
- Tighten screw for rear engine pad
- Reinstall exhaust pipe
- Install exhaust pipe on turbocharger (TC)
- Install screws for bracket for heated oxygen sensor (HO2S) cable
- Reinstall front cross member
- Install screw for front engine pad and torque rod mounting in sub-frame
- Install screw for ground lead and cable conduit
- Lower car and remove lifting beam from engine
- Install remaining screws for transmission and starter motor
- Install dip stick pipe and ground lead on transmission
- Install transmission cable on transmission and lever
- Install charge air pipe on charge air cooler (CAC) and connect upper oil hose to oil cooler
- Install air cleaner (ACL) and upper torque rod in engine compartment
- Finishing work
- Test drive form, description