Checking the ignition switch lighting

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2009 Volvo S60, 2008 Volvo S60, 2007 Volvo S60, 2006 Volvo S60, and 2005 Volvo S60. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Ignition OFF

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ignition off.
Check that the bulb is intact.

Check the connectors for the central electronic module (CEM) and ignition switch lighting. Check for contact resistance and oxidation. Check for loose connections. Check for damage carefully.

Check the power supply cable between central electronic module (CEM) terminal #19D (#B19) and ignition switch lighting terminal #5. Check for an open-circuit. Check for a short-circuit to supply voltage.

Check the ground lead between ignition switch terminal #6 and the ground terminal. Check for an open-circuit. Check for a short-circuit to supply voltage.

Remedy as necessary.

Other information
- To access the bulb and connector for the ignition switch, see Bulb, ignition switch, replacing
- To access the central electronic module (CEM), see Central electronic module (CEM), replacing
- To connect the breakout box, see Connecting the breakout box
- For information about signals, see Signal specification
- See Checking wiring and terminals
- For further information about the cables and ground terminals, see the Wiring Diagram.
Fig 2: Identifying Breakout Box
Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Ohmmeter
Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 4: Identifying Connector Terminals
Courtesy of VOLVO CARS OF NORTH AMERICA.

Continue
Refer to Verification