Signal missing: Verification

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2009 Volvo S60, 2008 Volvo S60, 2007 Volvo S60, 2006 Volvo S60, and 2005 Volvo S60. However, it is still accessible from the selected car via links, so may be relevant.

HINT: After rectifying a fault, a verification should be carried out.

Fig 1: Engine Start Verification

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Ignition ON Position

Courtesy of VOLVO CARS OF NORTH AMERICA.

Reinstall the connectors, components etc.
Ignition on.
NOTE:
For certain faults in the CAN-net where control modules have stopped communicating, it may help to disconnect/reconnect the battery to "restart" the control module/CAN-net.
- Erase diagnostic trouble codes (DTCs) in all control modules.
- Ignition off.
- Ignition on.
- Start the vehicle. Allow the vehicle to run for 10 minutes. Start the engine. Allow the engine to run at idle speed for 10 minutes
- Read out the diagnostic trouble codes in the vehicle via the DIAGNOSTICS tab.

Does the diagnostic trouble code (DTC) for faulty communication return?

YES
Refer to Information
NO
OKAY: Troubleshooting has been completed.