Diagnostic trouble code (DTC) information CEM-1A52
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2009 Volvo S60, 2008 Volvo S60, 2007 Volvo S60, 2006 Volvo S60, and 2005 Volvo S60. However, it is still accessible from the selected car via links, so may be relevant.
Condition
Diagnostic trouble codes (DTCs) are stored if the central electronic module (CEM) registers that communication with the driver's door module (DDM) is not operating.
NOTE:
In the event of CEM-1A5X diagnostic trouble codes (DTCs), the central electronic module (CEM) must not be replaced as the diagnostic trouble code (DTC) indicates a communication fault in the Control area network
Substitute Value
None.
Possible Source
- No power supply to the driver's door module (DDM)
- Open-circuit in the ground lead to the driver's door module (DDM)
- Contact resistance in the terminals
- Open-circuit in the wiring for the CAN low speed network to the driver's door module (DDM)
- The driver's door module (DDM) is not intended for this car (for example a used control module with different software/hardware).
HINT: If several diagnostic trouble codes (DTCs) are stored in the central electronic module (CEM) for communication faults with other control modules in the low speed network, this indicates a common fault in the Control area network, see the wiring diagram.
Fault symptom[s]
- Does not lock / unlock a door
- The driver's door switch panel does not work.