Checking the component and cable

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2009 Volvo S60, 2008 Volvo S60, 2007 Volvo S60, 2006 Volvo S60, and 2005 Volvo S60. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Ignition OFF

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ignition off.
Check the cable between central electronic module (CEM) connector terminal #D60 and the 50-supply to ignition switch connector terminal #7. Check for an open-circuit. Check for a short-circuit to ground.

The voltage must be battery voltage when the key is in the ignition position III.

Other information:
- See Connecting the breakout box
- See Signal specification
- See Central electronic module (CEM), replacing
- See Contents
Fig 2: Identifying Breakout Box
Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Central Electronic Module (CEM) Connector Terminals
Courtesy of VOLVO CARS OF NORTH AMERICA.

Is the voltage the same as battery voltage?

YES
Refer to Verification
NO
Refer to Replacing ignition switch connector