Checking the component and cable

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2009 Volvo S60, 2008 Volvo S60, 2007 Volvo S60, 2006 Volvo S60, and 2005 Volvo S60. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Ignition OFF

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ignition off.
Check the cable between central electronic module (CEM) connector terminal #3B and ignition switch connector 15A terminal #1. Check for an open-circuit. Check for a short-circuit to ground.

Other information:
- The voltage must be the same as battery voltage if the key is in position II or III
- To access or replace the central electronic module (CEM) connector, see Central electronic module (CEM), replacing
- For the intermediate junction point see appropriate wiring diagram.
- To connect the breakout box to the control module, see Connecting the breakout box
- For further information about signals and other values, see Signal specification
- See Checking wiring and terminals .
Fig 2: Identifying Breakout Box
Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Ohmmeter
Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 4: Identifying Central Electronic Module (CEM) Connector Terminals
Courtesy of VOLVO CARS OF NORTH AMERICA.

Is the voltage the same as battery voltage?

YES
Refer to Verification
NO
Refer to Replacing ignition switch connector