Checking the control module

Fig 1: Identifying Ignition OFF

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Connectors

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Connecting Control Module

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off
• The breakout box connected
• Connect the control module.
• Transmission connector D disconnected.

  Check the transmission control module (TCM) by measuring the resistance between terminals #A51 (#A51) and #B9 (#A69) on the breakout box. The resistance must be approximately 9 kΩ.

  NOTE:

  When removing the transmission connector, the control module may store diagnostic trouble codes (DTCs) for the gear-shift position sensor, the shift solenoids, the temperature sensor etc.

  Try a new control module if the resistance is infinite.

  Other information: 

  • To disconnect the transmission connectors, see Connectors transmission, disconnecting / connecting
  • To replace the control module, see Transmission control module (TCM), replacing
  • For information about signals, see Signal description. Transmission control module (TCM) .
  Fig 4: Identifying Breakout Box

  Courtesy of VOLVO CARS OF NORTH AMERICA.
  Fig 5: Identifying Ohms Display

  Courtesy of VOLVO CARS OF NORTH AMERICA.

Was the resistance OK? 

• YES 

  FAULT NOT FOUND:  Troubleshooting has been completed.

• NO 

  Refer to Verification