Gearbox And Gearshift Position Sensor - Checking/Adjusting, Removal And Installation
- Transmission
- Gearbox, removing
- Notes
- Gearbox, removing (AW55-50 -2000)
- Notes
- Preparatory work
- Removal
- Disconnecting the battery lead
- Removing engine compartment components
- Removing components from the gearbox
- Removing the gearbox mounting screws
- Removing the coolant hose from the passenger compartment heater
- Installing the lifting beam and lifting hook on the engine lifting eyelet
- Removing the air baffle and splash guard under the engine
- Removing the screw for the cable duct
- Removing the cross members from the body
- Removing the screws and nuts for the engine pads, torque rod
- Measuring the position of the tie rod in the steering gear
- Exposing the steering shaft joint
- Removing front suspension components (both sides)
- Preparations when removing gearbox
- Preparations for lowering the sub-frame
- Removing the right-hand drive shaft
- Removing the left-hand drive shaft
- Lowering the sub-frame
- Removing bevel gear
- Removing the rear engine mounting
- Removing the screws from the torque converter
- Removing the oil pipe from the gearbox
- Lowering the engine and the gearbox
- Installing the fixture on the mobile jack and gearbox
- Removing all the screws for the gearbox and engine
- Removing the gearbox
- Gear-shift position sensor, checking/adjusting
- Notes
- Gear-shift position sensor, checking/adjusting (AW55-50 1999)
- Notes
- Removing engine compartment components
- Remove the gearbox cable from the bracket and the lever. Move the cable to one side
- Checking the setting
- Adjusting the gear-shift position sensor
- Installing the cable duct
- Installing the gear selector cable
- Installing engine compartment components
- Checking the diagnostic trouble codes (DTCs)
- Gear-shift position sensor, checking/adjusting (AW50-42 1999-)
- Gearbox, removing