Automatic Transmission (Aw50-42) - Removal And Installation
- Transmission
- Test Drive Form, AW 50-42 automatic transmission, description
- Transmission, removing
- Notes
- Disconnecting the battery lead
- Removing engine compartment components
- Removing the upper torque rod
- Removing the coolant hose from the heater unit
- Blocking the hose between the brake fluid reservoir and the clutch master cylinder
- Removing the gear cables from the levers and attachments on the gearbox
- Removing the mounting screws from the gearbox
- Installing the lifting beam and lifting hook on the engine lifting eyelet
- Removing splash guards
- Removing components around the sub-frame
- Removing links, tie rod and bolt for the drive shaft
- Removing the nut from the ball joint (both sides)
- Removing the screws from the sub-frame support plates (both sides)
- Removing stub axle from the control arm
- Removing the drive shaft from the stub axle (right-hand side)
- Removing the sealing ring for the CV joint housing from the stub axle
- Removing the cap for the drive shaft support bearing
- Pressing up the sub-frame on the right-hand side
- Removing the screws for the torque rod from the gearbox
- Removing the cross members
- Removing the bracket for the power supply cable for the heated oxygen sensor (HO2S) from the sub-frame
- Removing the left drive shaft from the gearbox
- Removal of the front propeller shaft, (Only applies to AWD)
- Removing bevel gear
- Removing the screw for the rear engine pad
- Removing the rear engine mounting
- Lowering the engine and transmission
- Preparations when removing gearbox
- Installing fixture to mobile jack
- Removing the gearbox
- Transmission, installing
- Notes
- Checking before installing
- Adjust the position of the engine / transmission
- Install and tighten the screws for the transmission
- Install the torque converter screws
- Install the sub-frame components
- Lift up the engine and transmission to the horizontal position
- Install the rear engine mounting
- Install the sub-frame on the bodywork
- Install the left drive shaft on the transmission, the wheel spindle and the control arm
- Install the right drive shaft in the transmission, the wheel spindle and the control arm
- Install and tighten the sub-frame screws
- Install the oil pipe on the transmission
- Install and tighten the suspension components (both sides)
- Tighten the ball joint pinion
- Install new lock nuts on the steering gear
- Tighten the screw for the rear engine pad
- Reinstall the exhaust pipe
- Install the exhaust pipe on the turbocharger (TC)
- Install the screws for the bracket for the heated oxygen sensor (HO2S) cable
- Reinstall the front cross member
- Install the screw for the front engine pad and the torque rod mounting in the sub-frame
- Install the screw for the ground lead and the cable conduit
- Lower the car. Remove the lifting beam from the engine
- Install the remaining screws for the transmission and starter motor
- Install the dip stick pipe and the ground lead on the transmission
- Install the transmission cable on the transmission and the lever
- Install the charge air pipe on the charge air cooler (CAC). Connect the upper oil hose to the oil cooler
- Install the air cleaner (ACL) and the upper torque rod in the engine compartment
- Finishing work