Diagnostic trouble code (DTC) information

Condition

Fig 1: Identifying Clutch Pedal Push Rod And Position Sensor

Courtesy of VOLVO CARS OF NORTH AMERICA.

Diagnostic trouble code (DTC) ECM-9300 is stored if the engine control module (ECM) registers a fault in the PWM signal from the clutch pedal position sensor when the ignition is switched on.

Substitute Value

Cruise control switched off.

Possible Source

Signal too high:

Short-circuit to supply voltage in the signal cable
Defective clutch pedal sensor.

Signal too low:

Short-circuit to ground in the signal cable
Defective clutch pedal sensor.

Faulty signal:

Open-circuit in the signal cable
Incorrectly installed clutch pedal sensor
Defective clutch pedal sensor.

Fault symptom[s]

Cruise control does not function at all.