Checking the control module

Fig 1: Identifying Ignition ON

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Connectors

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ignition off
Connect the breakout box to the control module without connecting the breakout box connector to the transmission
Transmission connector disconnected
Ignition on
Gear selector in position P
Connect a voltmeter between terminals #51 (#A51) and #53 (#A53) on the breakout box
Activate solenoid SL.
The voltage must oscillate between approximately 0 and 12 V. If the voltage does not oscillate, replace the control module.

NOTE:
When disconnecting the transmission connector, the control module may store diagnostic trouble codes (DTCs) for the gear-shift position sensor, the shift solenoids and temperature sensor etc.

Other information:
- To disconnect the transmission connector, see Connecting the breakout box, GM automatic transmissions
- To replace the control module, see Transmission control module (TCM), replacing
- For information about signals, see Signal specification .
Fig 3: Identifying VCT2000 Diagnostic Tool Symbol In VIDA
Courtesy of VOLVO CARS OF NORTH AMERICA.

Does the voltage oscillate?