Checking the control module connectors

Fig 1: Identifying Ignition ON

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Connecting Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Connecting Control Module

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off.
• Check control module terminal #6 for contact resistance and oxidation and for loose connections. Remedy Contact resistance and oxidation . Remedy Loose connections (terminals) .
• Connect the control module.
• Connect the selector switch.
• Connect the Volvo Scan Tool (ST) to the data link connector (DLC).
• Ignition on.
  Fig 4: Identifying 14-Pin Connector

  Courtesy of VOLVO CARS OF NORTH AMERICA.
  Fig 5: Identifying Scan Tool

  Courtesy of VOLVO CARS OF NORTH AMERICA.
  • Activate the Scan Tool (ST) in MODE 2.
  • Move the ON/OFF switch to the ON position.
  • Activate the SET- switch
  • Check whether response code 1-3-1 is returned.

Is response code 1-3-1 returned? 

• YES 

  Refer to Fault-tracing information 

• NO 

  Refer to Replacing the component